detected invalid spectrum file path

Hi,

I worked on a CCPN project and saved it, but when I try to open it again (after closing it for a few min it says “detected invalid spectrum file path, please inspect file paths”

But if I close and open the CCPN project within a few minutes, it does work. And I did not change the path.

Thx!

Hi,

could it be that the spectrum is saved on a remote disk? If that is the case it could be that it if the connection is down it can’t detect the file path, but once the connection is back up again, it’s fine.

On the whole, if the spectrum file can’t be accessed it will mean you can’t see any of your contours, but it shouldn’t compromise the project. If you go to Spectrum / Validate paths… then you can check whether the file path can be found or not - and if necessary change it.

Best wishes,

Vicky